Tee flow switch control work: The flow switch is used to monitor the fluid flow in a closed pipeline and then provide a switch ON/OFF output signal as a set point. When the flow rate is higher or lower than the set value, the water flow switch sends a switch or alarm signal to the control system. The control system will do corresponding actions to control the water flow, for example, when the flow exceeds the upper limit or lower limit, the flow switch will generate a switch signal to turn on the pump or turn off the pump. Flow switches are developed based on flow meters and flow sensors. The whole flow switch usually needs two parts: the flow measurement part and the switch signal module. The switch signal is sent on the flow rate value. Therefore, the real-time flow rate is the determining factor of the accuracy of the flow switch.

Orientation and location:
Tee flow switch manufacturers tell you that vane and paddle flow switches must face the water flow. However, they may hang from pipes that run vertically or horizontally. A standard location for these switches is after or after the check valve or isolation valve, slightly downstream from where the water enters the sprinkler system.
When the flow exceeds a predetermined rate, the water flow switch is activated. However, they could also use a mechanism to delay these signals to prevent false positives due to pressure fluctuations.
Tee flow switch manufacturers tell you that they typically have two electronic switches: one that signals the fire control panel, and one that sounds a chime or other audible and visual alarm. A flow switch connected to a control panel must have a non-silencing circuit, which means the panel cannot disable the switch's alarm signal.
The flow switch is mainly installed online or plug-in in water, gas, oil and other medium pipelines to monitor the water flow in the water system. The manufacturer of the Tee flow switch tells you that when the water flow rate is higher or lower than a certain set point, an alarm signal is triggered and sent to the unit, and the system can make corresponding instructions after obtaining the signal. Avoid or reduce host "dry burning".
The flow switch is to command the switch of the system according to the flow. Set the upper limit or lower limit for the flow switch. When the flow reaches the limit value, the flow switch will send out a signal or alarm, and the system will run or stop. Tee flow switch manufacturers tell you that generally flow switches are used in systems that require flow. Depending on the system, the flow switch model and other factors, the place of use is also different, and it depends on the specific situation.