Manufactured and designed with high-tech equipment, paddle flow switches are ideal for monitoring liquids in pipelines. This is a budget-friendly alternative with extremely high safety for use in industrial facilities.

Install the paddle flow switch device:
1. The length of the paddle establishes an approximate angle to form a flow switch unit. Determine the length from the lowest point of the paddle while measuring the diameter of the pipe and reed switch. The paddle flow switch manufacturer tells you to isolate the paddle at the ideal pipe size mark or as you wish but not less than 1 inch left.
2. The paddles should be parallel to the cut surface of the pipe, and the mounting screws are 1 inch NPT.
3. On the screw hex, the flow marks should be parallel to the ground and the pipe.
4. Before installing the device to the T-pipe, make sure to thread the tape seals onto the screws and then tighten.
Since the paddle flow switch has a very important and integral part in the industry, the flow needs to be perfectly calibrated. Liquid flow rates can be accurate by measuring changes in dynamic velocity or energy. The velocity is dependent on the pressure change forcing the liquid through the pipe or conduit. Since the cross-sectional area of ​​the pipe is known and constant, velocity will be a surprising indicator of flow velocity. The paddle flow switch manufacturer tells you that calibrating the flow rate is important because it helps set the flow switch to a pre-determined off function.