The Tee flow switch manufacturer tells you that the flow switch is designed based on the principle of temperature change of the probe head. The probe has a built-in heat sensor and thermal sensor, and is in contact with the medium. The Tee flow switch manufacturer tells you that when measuring, the heat sensor emits constant heat. When there is no medium flowing in the pipe, the heat received by the heat sensor is a constant value. When there is a medium flowing, the heat received by the heat sensor will be With the change of the flow rate of the medium, the thermal sensor converts the temperature difference signal into an electrical signal, and then converts it into a corresponding contact signal or an analog signal through the circuit.

Installation of flow switch:
1. The Tee flow switch manufacturer tells you that the flow switch must be installed on a straight pipeline, and there are at least 5 times the diameter of the straight pipeline on both sides.
2. The manufacturer of the Tee flow switch tells you that when screwing the flow switch into the tee of the pipeline, in order to prevent the switch from being damaged, it is not allowed to hold the shell for installation. You must use a hexagon wrench to hold the hexagon of the valve body for installation.
3. The Tee flow switch manufacturer tells you that when the flow switch is tightened, the flow direction piece should be perpendicular to the flow direction of the fluid, and the direction of the arrow on the flow switch shell should be consistent with the flow direction of the fluid in the pipeline.
4. The Tee flow switch manufacturer tells you that the flow switch can be installed in horizontal pipes or vertical pipes with upward liquid flow, but not in pipes with downward liquid flow.
5. The manufacturer of the Tee flow switch tells you that the flow switch cannot suffer from water hammer. If a quick closing valve is installed under the water flow switch, a suitable restrictor must be used to prevent the flow shock.