LKB-01D(15) Tee flow switch
Tee flow switch is one of the main products of Canto Switches with good price and quality, factory direct sales and factory supply. Our company is a professional supplier and manufacturer in China, with various products on sale and Discount.
Tee flow switch Product Description
The LKB-01D Tee Type Paddle Flow Switches are Single - Pole, Double - Throw (SPDT) flow switches that are used in liquid lines carrying water ,ethylene glycol,or other liquids not classified as hazardous. They can be wired to energize one device and de-energize another device powered from the same source when liquid flow either exceeds or drops below the set flow rate.
Note: The LKB-01D Tee Type Paddle Flow Switches can not be used where the liquid in the pipes will drop below the liquid's freezing point, causing an internal freeze-up.
Dimension Chart(mm) Standard Installation Tee flow switch Mounting: Flow switch should be mounted in a horizontal pipe line or vertical pipe line.Mount the instrument in a section of pipe where there is a straight run of at least 5 pipe diameter on each side of the flow switch. Tee flow switch To Adjust Setting: 1.Remove switch cover. 2.For higher flow rate, turn flow rate adjusting screw counterclockwise. 3.For lower flow rate, tur flow rate adjusting screw clockwise. 4.Make sure flow switch cover is assembled before leaving.
Tee flow switch CAUTION: Equipment damage hazard.Position Adjusting Screw is not intended to be changed.Adjustment attempts may damage the control or cause loss of calibration,voiding the warranty. |
Flow Velocity Chart
Pressure Loss Rate Chart |
Tee flow switch Electrical Parameter
Rated Amps(A)\Rated Voltage(V) | Horsepower | 125 VAC | 250 VAC | |
Non-inductive Amps | 1 | 15 | 15 | |
Inductive Amps | Rated Amps | 0.75 | 3.5 | 2.5 |
Locked Rotor Amps | 0.45 | 21 | 15 |
Type Ordering
Nominal Diameter |
A: BSP pipe /B: Metric pipe |
Pipe Connector |
Adjustment Range(L/min) |
15 | A | RC 1/2” | 3~11 |
B | 5~1 7 | ||
20 | A | RC 3/4” | 4.2~18 |
B | 8.3~37 | ||
25 | A | RC1” | 5.2~23 |
B | 10~48 |
Nominal Diameter |
Switching Differential(L/min) |
Repeatability Error | |
Normal | High End | 2.5% | |
15 | 2.5 | 1.5 | |
5.5 | 2.5 | ||
20 | 3.6 | 2 | |
7.2 | 3 | ||
25 | 4.5 | 2 | |
9.3 | 4 |
Note: A means BSP pipe, B means Metric pipe.
Note: due to continuous product improvement, the appearance of the actual product may differ slightly.
Related Products
Hot Products Related To This Item
©Canto Switches 浙ICP备20001258号-2